Sunday, June 4, 2006
HOW TO: Using a Cat5e Jack (RJ-45) for use with a Telephone Connector (RJ-11)

I had a gentlemen write me for instructions on how to use an extra Cat5e jack with a telephone. I thought the information might also be useful to others out there so I’m posting it here.
I use the T-568A wiring standard for home use. So, if you want to use a Cat5e (RJ-45) jack as a telephone interface you need to wire it as following:
Green and Red wires on standard bell systems are tip and ring for line one of service. The Black and Yellow are tip and ring for line two of service. If you have a telephone system, like a Panasonic KSU, you need both pairs since it uses the others to send status information like CO, Time, Date, Caller ID, and the likes using the phone systems proprietary protocol.
- Blue on the RJ-45 jack is equal to Green
- Blue/White on the RJ-45 is equal to Red
- Orange on the RJ-45 jack is equal to Black
- Orange/White on the RJ-45 jack is equal to Yellow
It’s that simple… you can either punch in standard 4-conductor telephone cable into the jack or you can use Cat5e and then when you connect it to your phone junction box you can connect the colors from the cat5 to the colors I have listed above.
SPONSORED ADVERTISEMENTS
COMMENTS
how would I go about connecting RJ12(6 conductor) wire to a RJ45 male connector?

Welcome to mavromatic! My goal is to bring to your attention the latest DIY projects, the greatest home automation and home theater products. As well as, the occasional offbeat entry, to spice things up a bit. 


