… continued from part I.
It’s been a while since I last posted an update on the mavroOBD project. After a few (3) board revisions, I’m happy to report that I’ve successfully miniaturized the Arduino UNO (ATMega328P based AVR) and SeeedStudio CANBus shield into a compact OBD module form factor. Next, I will begin the coding portion and will post updates as that happens. Feel free to post a comment if you are interested in helping out with this project.
This is an open source project and all files are available here on Github.
Please Note:
Your safety is your own responsibility. These projects are not intended for use by children. Use of the instructions and suggestions on Mavromatic is at your own risk. Mavromatic, disclaims all responsibility for any resulting damage, injury, or expense. It is your responsibility to make sure that your activities comply with applicable laws.

View Comments (8)
Great board! We featured it in our project spotlight this week. Check it out at http://openfet.com/
Great board! We featured it in our project spotlight this week. Check it out at http://openfet.com/
Great board! We featured it in our project spotlight this week. Check it out at http://openfet.com/
Thanks! I'll take your advise and add the suggested license.
love it ;)
is it possible to stack a second board on it to use a ms & hs CAN?
This looks so cool! !
I just share a spy store to you http://www.wiseupshop.com/
This looks so cool! !
I just share a spy store to you http://www.wiseupshop.com/
This looks so cool! !
I just share a spy store to you http://www.wiseupshop.com/