Posts Tagged ‘Front’
Sunday, March 18th, 2007
DIY: Part II — Replacing Front Rotors and Brake Pads on a Land Rover Discovery II
In Part I, I changed the rear rotors and pads of my Land Rover Discovery II. Last weekend, I tackled Part II, changing the front set. The process isn’t much different than the back except that the caliper and pads are much bigger.
The only additional tools you will need from the rear change is a 19mm 12pt socket with a short extension. The caliper is bigger, so are the bolts holding it. Also, you will need to be a bit careful with the ABS sensor. There is a mounting that holds the sensor in place, you will need to gently remove the wire from the mounting plate so you can get your socket wrench to the bolt. Once you remove the caliper, compressing the piston (two of them) and brake pads is exactly the same as the rear.
Completed front rotor and brake pads…
Monday, March 5th, 2007
DIY: Part I — Replacing Rear Rotors and Brake Pads on a Land Rover Discovery II
I used to take my truck into the dealer to get it serviced, which over charged me and coincidently would cause other things break. Now I try to do most work myself. The brake pads and rotors (front and back) on my 2001 Land Rover Discovery II needed replacement. I ordered genuine parts from the nice guys over at Rovers North for almost half of what the dealer wanted to charge me (just for parts!). You will need the following part numbers for the rear: SDB000470 (rotor, you will need two of these), SFP500130 (pair of pads). The pads come with replacement bolts, but remember to also order two replacement rotor placement screws since you will probably strip it when you remove the old one — like I did. In part 1, I will be showing how to replace the rear pads and rotors. Part 2, will be about the front, which should be very similar to the back. Let’s get started…
Changing brakes and rotors is a messy job. You will need the following tools:
Jack Stand (for safety), Pump Jack, Gloves, Hammer, Impact Driver with #4 bit, 12mm 6pt Socket, 12mm Wrench, 13mm 12pt Socket, 13mm Wrench, Tire Bolt Wrench, C-Clamp, Brake Cleaner and some WD40.
If you are just changing you brake pads, you will be done in about 15 mins. Just skip down to the “Brake Pad Replacement” section.
The first thing I did was remove the rotor placement screw since that is where most of your time will be spent. This was the hardest part when replacing my Discovery brake disc (rotor). I used a Craftsman Impact Driver with a #4 bit and just pounded it until it loosened. The rear driver side screw completely stripped which made it even harder. I used an oversized slot bit (included with the Impact Driver) and pound on it until it released.
Using the Impact Driver To Remove Screw
What a stripped screw looks like.
Once you get the screw loose, remove the caliper mounting bolts. These are the 13mm 12pt bolts. Make sure you have a 13mm 12pt socket or a 13mm combo wrench since these bolts are also pretty hard to loosen. I used a little WD40 to help it a bit.
When you have the caliper removed, tie it up or place it on a 5 gal bucket. Then pull the …
About the archives
Welcome to the archives here at MAVROMATIC.
These are a collection of our previous posts. If you'd like to read about the latest and greatest, click here.